Nearly all of the time, businesses would spend lots of money to buy their lift trucks. It is important, therefore to take proper care of your machine to protect your investment into the long run. It is really a good idea to know the procedures that are undertaken during the care and maintenance of this piece of equipment.
Among the best ways to tell how good the engine is working is by starting the forklift up and listening closely to see how it runs. For example, if there are any knocks or misses, the equipment is faulty and this must raise some issues. In addition listen closely for any squealing noise which come from the belts since these noises would provide you with a wealth of information.
When doing maintenance, some of the main components you will have to pay attention to comprise the horn, safety warning devices, the lights, the gauges and the overhead guard. Any burnt out light bulbs or faulty components should be replaced as soon as they are noticed. It is also essential to inspect the wiring.
When the above components have been checked thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell must be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The fuel filters, hydraulic filter and the transmission filter must be replaced regularly. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be performed. If there is a grease fitting on the axle make certain to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. Next, check every other component of the equipment like the wheels. If any kind of fault or issue is detected, be certain to address it immediately in order to make certain the equipment is working at its safest and optimum levels.