Change a Propane Tank
Propane fueled forklifts are normally utilized in warehouses. The lift truck is designed with the propane tank mounted at the rear of the driver. The tanks, which look much like beer kegs, need to be replaced from time to time because they have a limited lifespan. Drivers of forklifts should use caution when handling propane tanks. Compressed gases are dangerous, especially since the gas is flammable. Use caution when removing and replacing propane tank to prevent being injured.
1 To change a propane tank, first stop the forklift while leaving the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off inside the transfer hose which connects the tank and the engine. Prior to taking the second steps, wear the correct safety equipment, like insulated gloves made of either leather or neoprene. It is important for you to protect your skin from touching the compressed gas, that is extremely cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When putting in a new tank, reconnect the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 Leaks can be checked simply by applying soapy water to the valve and opening it slightly. If there is a leak, it would cause bubbles to froth from around the valve. If this occurs, inspect the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks around the area of the valve, and after that perform the leak checking process again. Persistent leaks mean that both the nut and connecting hose should be replaced. Nevertheless, if replacing the nut and hose still does not stop the leak, the tank must be replaced.
4 Lastly, open the valve all the way to enable the gas to fill the connecting hose. After that you could start the forklift and resume operating.